Ready-made kit for spraying polyurethane Foam Kit

[zihadhosenjm40]

As a rule, if thermal insulation is carried out by specialists, the owners only need to prepare the surfaces for their arrival. The wall, partition or ceiling that requires insulation must be dry and clean. It is necessary to remove debris and remove scraps of peeling paint. The surface temperature for better adhesion (sticking) of polyurethane foam should not be lower than +10˚.

Polyurethane foam is applied quickly. In just 20-30 seconds, the insulation expands to the required volume and begins to harden.

Cost of equipment for spraying polyurethane foam with your own hands
The popularity of portable units for independent work with polyurethane foam is explained by the fact that in private houses the area for insulation can be very small. Teams of new zealand mobile database workers with expensive equipment simply do not go to such sites, as it is unprofitable. In other cases, small jobs will cost a lot due to the lengthy assembly of the units. Disposable kits are designed for safe use by amateurs. On areas less than 20 m2, they are profitable.

The average cost of a one-time installation is from 16 to 30 thousand rubles. It contains approximately 1 m3 of polyurethane foam. The same volume of the composition, purchased from a specialized company, will cost more than 30 thousand rubles. The benefit of doing it yourself is obvious.

The disposable system for insulation of polyurethane foam, Touch*n Seal Foam Kit, made in the USA, is presented in the following configuration:



2 cylinders, sufficient for private use, filled with polyurethane foam.
Hose – 4 m.p.
Sprayer - "pistol".