For floor beams in a hanging system, use hewn logs or fairly thick bars installed on edge. Their cross-section should be

[zihadhosenjm40]

Layered system

The layered system, unlike the hanging system, is supported not only by two external load-bearing walls, but also by capital partitions installed on the foundation. Therefore, when planning the construction of an attic, it is necessary to think in advance about the design of the strip foundation on which the capital partitions will be installed. The layered system is perfect for the construction of an attic, since it can withstand high loads, compared to the hanging version. It provides a good foundation for the floor beams and, accordingly, for the attic floor.


If you are making a broken version of a costa rica mobile database roof, then it makes sense to use a combined roofing system, that is, the side rafters are installed in a layered manner, and the ridge rafters are installed in the form of a hanging system.

When building a house from blocks or bricks with an attic, its front side is often built from the same material. This is convenient, because you do not have to calculate the parameters of these roof elements and assemble them from bars, after which you raise them to the wall. But it is important to understand that the walls of the building must necessarily stand on a reliable foundation and have a good thickness, since such a pediment gives a significant load to the main building.


If the attic serves as another floor all year round, then a gable wall made of foam blocks or bricks is an excellent option for creating a living space under the roof.

In order for the attic rooms with a gable roof to be spacious and have a normal height, the angle of the roof slopes should be approximately 45-50°, depending on the width of the end part of the structure. If you take a smaller angle, the volume of the room will be significantly reduced. Increasing the steepness of the slopes will make the roof unreasonably high, it will become heavier, will have a greater sail area under wind load, and the cost of materials will be inappropriate.