Is it necessary to remove and disassemble the column?
Posted: Tue Feb 18, 2025 4:22 am
The elements must be cleared according to the algorithm:
heat exchanger;
water supply unit;
jets;
other constituent components.
The process of removing scale is not complicated, the main rcs data is to correctly stretch the membrane during assembly so that it springs, but does not hang down or is tightly fixed. When cleaning a gas water heater for the first time, it is recommended to act under the supervision of a specialist.
How often to clean the column
The gas water heater should be serviced at least once every 2-3 months, visually inspecting the surface of the parts. Clean the unit once every six months using folk remedies or household chemicals.
To thoroughly flush the heating device, you need to remove and disassemble it. Open the housing, inspect the filter, membrane, radiator, clean it with chemicals or folk methods. To reduce the appearance of scale, which will allow you to disassemble and clean the entire column less often, you can flush the radiator once every 2 months without removing it.
Cleaning the heat exchanger without removal
To carry out the procedure you need:
Disconnect the water supply pipe.
Place a rubber hose on the outlet pipe.
Open the tap and drain a small amount of liquid, no more than a liter.
Use household rust cleaning powder, after diluting the mixture with hot water.
Pour the solution into the pipe in a thin stream. Leave the radiator in this state for 2 hours.
Open the tap, drain the contents, and rinse the structure.
heat exchanger;
water supply unit;
jets;
other constituent components.
The process of removing scale is not complicated, the main rcs data is to correctly stretch the membrane during assembly so that it springs, but does not hang down or is tightly fixed. When cleaning a gas water heater for the first time, it is recommended to act under the supervision of a specialist.
How often to clean the column
The gas water heater should be serviced at least once every 2-3 months, visually inspecting the surface of the parts. Clean the unit once every six months using folk remedies or household chemicals.
To thoroughly flush the heating device, you need to remove and disassemble it. Open the housing, inspect the filter, membrane, radiator, clean it with chemicals or folk methods. To reduce the appearance of scale, which will allow you to disassemble and clean the entire column less often, you can flush the radiator once every 2 months without removing it.
Cleaning the heat exchanger without removal
To carry out the procedure you need:
Disconnect the water supply pipe.
Place a rubber hose on the outlet pipe.
Open the tap and drain a small amount of liquid, no more than a liter.
Use household rust cleaning powder, after diluting the mixture with hot water.
Pour the solution into the pipe in a thin stream. Leave the radiator in this state for 2 hours.
Open the tap, drain the contents, and rinse the structure.