The arrangement of several pipes must be carried out on one line;
Posted: Mon Feb 17, 2025 8:35 am
Where to install the ventilation pipe
The location of ventilation pipes must be established at the stage of building design. The ventilation pipe must be brought out to the roof in accordance with the standards and rules of house building. To ensure good ventilation, it is necessary to take into account the wind rose of the area.
When installing ventilation pipes on a roof made of metal tiles, you should keep in mind:
point ventilation outlets must be located at a distance of 60 square meters from each other;
the more complex the roof structure, the more ventilation pipes;
the ventilation pipe should not be further than 60 cm from the ridge;
the places where the pipe is removed must be tightly sealed;
Markings for determining the locations for fastening and chinese malaysia data the pipe are made by drawing a template included in the kit with the material.
It is recommended to install ventilation pipes under the riser. This method will ensure maximum air circulation. Sometimes, corrugated pipe adapters are used for this purpose.
If the roof is pitched, then the ventilation pipes are installed closer to the ridge.
When installing the connection, the base of the corrugated pipe will be warm, which will provide the greatest wind resistance to the pipe itself.
The height of the riser pipe is important; if the pipe is too low, there will be poor draft, and if the pipe is too high, it will be necessary to additionally secure it with special devices.
Building codes stipulate the height of ventilation pipes:
for flat roofing - no more than 30 cm;
for a pitched roof - no more than 50 cm.
If the roof provides additional functionality (platforms, places for rest), then the height of the ventilation pipe should not exceed two meters.
The location of ventilation pipes must be established at the stage of building design. The ventilation pipe must be brought out to the roof in accordance with the standards and rules of house building. To ensure good ventilation, it is necessary to take into account the wind rose of the area.
When installing ventilation pipes on a roof made of metal tiles, you should keep in mind:
point ventilation outlets must be located at a distance of 60 square meters from each other;
the more complex the roof structure, the more ventilation pipes;
the ventilation pipe should not be further than 60 cm from the ridge;
the places where the pipe is removed must be tightly sealed;
Markings for determining the locations for fastening and chinese malaysia data the pipe are made by drawing a template included in the kit with the material.
It is recommended to install ventilation pipes under the riser. This method will ensure maximum air circulation. Sometimes, corrugated pipe adapters are used for this purpose.
If the roof is pitched, then the ventilation pipes are installed closer to the ridge.
When installing the connection, the base of the corrugated pipe will be warm, which will provide the greatest wind resistance to the pipe itself.
The height of the riser pipe is important; if the pipe is too low, there will be poor draft, and if the pipe is too high, it will be necessary to additionally secure it with special devices.
Building codes stipulate the height of ventilation pipes:
for flat roofing - no more than 30 cm;
for a pitched roof - no more than 50 cm.
If the roof provides additional functionality (platforms, places for rest), then the height of the ventilation pipe should not exceed two meters.