How to make a harness
Posted: Sun Feb 09, 2025 10:29 am
The drain must be planned so that water cannot accumulate anywhere in it. For this, you can use an ordinary plastic sewer pipe with a diameter of 40 or 50 mm, fixing it, for example, to a metal tape for mounting plasterboard or to another fastener every 50-70 cm of the pipe, to the lower trim of the bathhouse or to the subfloor.
Attention! The minimum permissible slope for water drainage is 1:30, i.e. approximately 3-3.5 cm per 1 meter of pipe.
To prevent cold air from entering through the drain under the bathhouse on screw piles, there is a very simple, proven and cheap way - put a rubber ball with a diameter of 40-60 mm on the drain hole. When water enters there, the ball will float and release it. And when the water is not used, it will not allow cold air to enter the room.
Once the screw supports are installed, they need to be secured with beams. As a result, a rigid structure called a grillage (strapping) will be obtained. It acts as a ceiling, being located between the bathhouse and the foundation.
The grillage is made of beams, and brackets and metal corners are used to connect them. The strapping is attached to the supports with bolts or screws. Notches are made in the beam for partitions and joists. Thanks to the strapping (grillage), the weight of the building is distributed evenly on the foundation. Since the grillage is affected by many environmental factors, it must be protected.
It is necessary to put waterproofing between the cameroon mobile database the frame and the walls. All open areas of the timber must be covered with mastic, this will protect the frame from rotting.
Conclusions
Despite the apparent complexity, it is not so difficult to calculate and build a foundation for a bathhouse on screw piles with your own hands; in fact, this is one of the easiest types of foundations to make. And even a non-specialist can buy or make piles for a bathhouse himself, and then install them.
Construction of a bathhouse floor on screw piles
The floor in a bathhouse on screw piles must have good thermal protection, since there is quite a lot of free space under the building. If the bathhouse will be used in winter in a region with a cold climate, it is recommended to additionally protect the underground space by closing it around the perimeter with a base. Several vents are made in this enclosing structure, which make it possible to effectively ventilate the underground space, and at the same time create additional thermal protection.
Attention! The minimum permissible slope for water drainage is 1:30, i.e. approximately 3-3.5 cm per 1 meter of pipe.
To prevent cold air from entering through the drain under the bathhouse on screw piles, there is a very simple, proven and cheap way - put a rubber ball with a diameter of 40-60 mm on the drain hole. When water enters there, the ball will float and release it. And when the water is not used, it will not allow cold air to enter the room.
Once the screw supports are installed, they need to be secured with beams. As a result, a rigid structure called a grillage (strapping) will be obtained. It acts as a ceiling, being located between the bathhouse and the foundation.
The grillage is made of beams, and brackets and metal corners are used to connect them. The strapping is attached to the supports with bolts or screws. Notches are made in the beam for partitions and joists. Thanks to the strapping (grillage), the weight of the building is distributed evenly on the foundation. Since the grillage is affected by many environmental factors, it must be protected.
It is necessary to put waterproofing between the cameroon mobile database the frame and the walls. All open areas of the timber must be covered with mastic, this will protect the frame from rotting.
Conclusions
Despite the apparent complexity, it is not so difficult to calculate and build a foundation for a bathhouse on screw piles with your own hands; in fact, this is one of the easiest types of foundations to make. And even a non-specialist can buy or make piles for a bathhouse himself, and then install them.
Construction of a bathhouse floor on screw piles
The floor in a bathhouse on screw piles must have good thermal protection, since there is quite a lot of free space under the building. If the bathhouse will be used in winter in a region with a cold climate, it is recommended to additionally protect the underground space by closing it around the perimeter with a base. Several vents are made in this enclosing structure, which make it possible to effectively ventilate the underground space, and at the same time create additional thermal protection.