Connecting to the power grid
Posted: Sun Feb 09, 2025 5:29 am
In this case, if the pressure in the water supply exceeds 6 bar, it will be necessary to install a reducer at the inlet in front of the water heater, which will reduce the excess pressure.
Professionals recommend: to reduce heat loss in hot water pipes, it is advisable to install the boiler as close as possible to the water intake points. If this is not possible, it is worth installing thermal insulation on the pipes.
A storage water heater is a fairly powerful electrical appliance, for which a separate splash-proof high-quality socket should be installed. It should be located in a place maximally protected from moisture and have a ground terminal.
The supply line should be equipped with a RCD (residual current device) and a circuit breaker, which will protect the network from overload currents in the heater and possible short circuits.
The device rating is 16 A. Installation of an RCD is necessary to romania mobile database the user from possible electric shock from the water heater.
The device can be installed in a panel or in the form of an adapter. In this case, the leakage current rating cannot be greater than 30 mA with a minimum load of 16 A.
If desired, you can run a separate cable to the boiler, it will go directly from the meter. Before starting work, you need to soberly assess your strengths. Working with electrical wiring requires certain knowledge and skills.
Installation errors can result in electric shock and equipment failure. If you have no experience working with electricity, it is better to seek help from specialists.
Professionals recommend: to reduce heat loss in hot water pipes, it is advisable to install the boiler as close as possible to the water intake points. If this is not possible, it is worth installing thermal insulation on the pipes.
A storage water heater is a fairly powerful electrical appliance, for which a separate splash-proof high-quality socket should be installed. It should be located in a place maximally protected from moisture and have a ground terminal.
The supply line should be equipped with a RCD (residual current device) and a circuit breaker, which will protect the network from overload currents in the heater and possible short circuits.
The device rating is 16 A. Installation of an RCD is necessary to romania mobile database the user from possible electric shock from the water heater.
The device can be installed in a panel or in the form of an adapter. In this case, the leakage current rating cannot be greater than 30 mA with a minimum load of 16 A.
If desired, you can run a separate cable to the boiler, it will go directly from the meter. Before starting work, you need to soberly assess your strengths. Working with electrical wiring requires certain knowledge and skills.
Installation errors can result in electric shock and equipment failure. If you have no experience working with electricity, it is better to seek help from specialists.